Case IH combine harvesters

Case Combine Parts Maintenance Tips for Harvesters for Better Life

Harvesters are the bane for farmers, come harvest time. The preparations to make them ready begin as soon as one harvesting season ends. Maintaining your harvester Case Combine Parts takes away valuable time so you must make sure the machine is raring to go. Soon after the fall harvest, use these maintenance tips to get the harvester in shipshape condition.

Inspect Your Machine with Understanding

The first thing to do is to consult the manual for operations and go over it point by point. Compile a list of things that are lacking and the method of rectifying them. Do a superficial cleaning by removing debris and blowing off the dirt on the outside and the inside of the Case Combine Parts. If you do not do this, debris from the harvest will attract rodents that chew on the electrical components and wires.

Begin the Cleaning Process

Use water to wash the outer surface of the harvester. Take care to see that water does not enter any moving parts or the bearings. Clean the inside of the cab and see whether the weather stripping needs replacing. Keep something inside to take care of the rats. Blow out the heat exchangers and the radiator. This is also a good time to touch up the scratches and check the worn-out patches with fresh paint.

Check the Insides

Open the inspection plates and see how the insides of the Case Combine Parts are. Check the sieves and concaves and see if there is something that needs solving. If yes, replace or repair the worn parts. There could be corrosion in the bearings or the shaft. At times, these might be loose. If any bearings need replacing, change them.

After this, change the oil and filters and lubricate all fittings that need grease. Make sure the lights are working well and the switches are in good operating condition. As per your model, add a supplemental coolant additive if the level is not enough to protect against corrosion. Replace the coolant for cooling system protection according to the weather.

Go Over the Fields to Check the Condition

The field must remain smooth and even. Go over the field and see which places need smoothing over. Scan for obstructions and potential dangers and remove them. Choose the setting for your Case Combine Parts according to the grain you will harvest. Proper clearance between the rotating cylinder and the concave ensures a good flow of the grains

Ensure Good Physical Condition of the Harvester

Check and replace any damaged auger and conveyors as you go on. Also, check the walkers and bearings along with the inspection of the rotors and their alignment and their bearings. Check that the straw choppers are balanced and do not have any excessive vibrations.

Look for any kind of crack that exists and tighten all the belts. Also, keep an eye out for symptoms of dry rot.

Go over the unloading augers and the fountain and the paneling for the feeder house, especially the floor. Check the elevator chains and the house chains for wear and tightness. Grease the chains and add a fuel stabilizer if you are putting the harvester away for the winter.

Leave a Reply

Your email address will not be published.